Hi,
I’m new here, sorry if I am in the wrong place.
I run centos-release-7-8.2003.0.el7.cern.x86_64 and KDE 4.14.8
I would like to use kgraphviewer and I understand it can be installed only via snap based on these instructions: https://snapcraft.io/install/kgraphviewer/centos
Everything goes OK, except that during the snap install I get an error about the creation of the loop device. The snap install ends successfully.
A loop device is created anyway (mountpoint: /var/lib/snapd/snap/kgraphviewer/4), but when I run kgraphviewer, after a few seconds of loading, it stops with apparently no error message.
Any suggestions?